How to add storage to Proxmox

Using an HDD for the proxmox host, the VMs and the containers was causing delays and long iowait.After upgrading to an SSD there was a spare 1TB hard drive that could be used for storing containers that write constantly big chunks of data to the hdd,something that can cause increased wear to the ssd.

Since the needs are not complicated the setup is simple and does not use raid,zfs etc.

After the hdd setup, an elasticsearch stack container with netflow analysis was moved to the hdd,and although the read speeds do not match the performance of the containers running from the ssd, the hdd not having anything else running has an amazing increase in data read compared to the previous setup where the proxmox host and the VMs were based on the same hdd.

This tutorial covers the following subjects:

• How to partition and format a hard disk added to our baremetal host
• possible use cases for the new partition

Identify the new disk

Check the layout of the disks attached to the server to find the device names assigned to the disks by the proxmox host OS (Debian 9):

lsblk

In the example we have disks sda and sdb.

sda has the current debian os with Proxmox VE installed and some vms.The new disk is sdb which retains the old setup.We’ll clear all contents from sdb since we have already moved the vms to the new sda disk and verified they are working.

Format and partition

We’ll use parted instead of fdisk although they have equal capabilities.Parted can be used in scripting and supports disks bigger than 2TB.

check existence in the system and install parted:

apt policy parted

apt install parted

Create a new partition table of type GPT,a newer and better standard than the older MBR:

parted /dev/sdb mklabel gpt

Make a primary partition for filesystem ext4 utilizing 100% of the disk:

parted -a opt /dev/sdb mkpart primary ext4 0% 100%

Create the ext4 filesystem on the newly created partition sdb1 with a volume label we want.Giving a label to a partition is the recommended method since when adding or removing drives the device name sdb1 could change.

mkfs.ext4 -L storageprox /dev/sdb1

lsblk -fs

Now we can mount the drive in a folder we like.For a more unified appearence and ease of use we choose mnt/.

Create a folder inside mnt/ that will host the data of the new disk:

mkdir -p /mnt/data

Edit fstab file and enter a line with the mount options:

nano /etc/fstab

LABEL=storageprox /mnt/data ext4 defaults 0 2

mount the new drive:

mount -a

The HDD drive is now ready for use.Below we see common usage cases in Proxmox VE.

Use the new disk as backup

Backup our VMs and LXC containers in the new HDD drive.

Create a directory to store the backups:

mkdir -p /mnt/data/backup/

Now in the Proxmox GUI go to Datacenter -> Storage -> Add -> Directory.

In the directory option input the directory we created and select VZDump backup file:

Finally schedule backups by going to Datacenter – > Backups.The new directory will be available in the backup options.

Use the new disk to run VMs

As mentioned in the beginning of the article we can select specific VMs or containers that do heavy writing on the SSD to run from the HDD.

Create a directory for the VMs:

mkdir -p /mnt/data/hdd-img/

In the Proxmox GUI go to Datacenter -> Storage -> Add -> Directory .

In the directory option input the directory we created and select Disk image,container :

Now when restoring a backup image or creating a new VM or container, in the storage selection we have the option of hdd-img, the ID of the new storage we added.

GNOME RESELLER HOSTING